Slim 6-foot snow flocked artificial Christmas tree standing in a living room next to a fireplace, with wrapped gifts around the base

How to Fluff and Decorate a Slim 6 Foot Flocked Christmas Tree

A slim 6-foot flocked tree is a good fit for an apartment, a tight corner, or a room that still needs a walkway. The catch is that the snow on the branches marks easily, and a tree that is only about two feet wide will look sparse if you skip the fluffing or hang ornaments the same way you would on a full-width tree.

Plan on 25 to 40 minutes of quiet work, then leave the branches alone for the rest of the season. That is the whole trick.

Set it up in its final spot

Flocking sheds a little when the tree is handled, and a lot when you drag a finished tree across the room. Lay an old sheet under the spot, going a couple of feet past where the tips will reach. Close the nearest heating vent and turn off the ceiling fan while you work, because loose flock rides on moving air. Wear old clothes that are not fleece, and thin gloves so you are not tempted to squeeze the tips.

A tree like our slim 6-foot snow flocked Christmas tree is about 6 feet tall and roughly 23 and a half inches wide, with a folding steel stand and sections that stack on a center pole. Open the stand on the sheet, make sure it sits level, and tighten the lowest section before you add the next ones. If a section will not seat, lift it off and line it up again. Do not force it.

6-foot slim snow flocked Christmas tree shown with height and width markings, about 6 feet tall and 2 feet wide, next to a 6-foot person silhouette

This tree is for indoor use only. Keep it away from a fireplace, a space heater, and the direct blast of a floor vent, since heat and extra humidity soften the adhesive that holds the flock on.

Fluff gently, and only once

On a regular green tree you can really work the branches. On a flocked tree, that backfires. The snowy coating was applied after the branch was shaped, and every hard bend can crack it.

Start at the bottom section and work up. Reach in toward the pole first. The inner branches are what hide the trunk and close those dark holes people notice from the doorway. Hold each branch near its base, not by the flocked tips, and separate the smaller sprigs with light pressure. Fan them out: one a little up, one out, one to the side. If every tip points the same way, the tree still looks flat.

Then move out along the same branch and do the same with the outer tips. You want a loose, uneven fan, not a perfect row. On a slim tree those overlapping directions are what keep the outline from looking like a flat triangle.

Finish a section, step back, and look from the doorway or the sofa before you start the next one. A quick phone photo helps, because you see gaps in a picture that you miss up close. If you find a hole, open the inner tips around it and let two neighboring branches overlap a little. Do not crank one branch into a sharp angle to cover a big gap. If a space is still there after a gentle pass, leave it. You can fill it later with a pick or a lighter ornament. Reworking a flocked branch is how the snow ends up on the sheet.

The top section is narrower, so use smaller movements and leave a little structure for a topper. If it is easier, fluff that section in your hands before you set it on the pole. When you are done, fold the sheet in toward the middle and shake it out outside, then vacuum the floor. Do not wipe flock with a wet rag. It turns into a paste that is harder to clean.

Fully fluffed slim 6-foot snow flocked artificial Christmas tree on a folding black metal stand, photographed against a white background

Decorating a slim flocked tree

Because this tree is only about two feet across, less is better. Heavy ornaments and thick garland pull on flocked tips and make a slim profile look crowded.

If you are adding lights (this style of tree usually ships unlit), do that before ornaments, and weave the strand in toward the pole, not just around the outer edge. Lights that sit only on the tips make the tree look hollow. Work from the bottom up, and unplug the string while you are reaching into the branches.

Hang lighter ornaments, and put the slightly heavier ones on branches that angle up so they do not slide. Keep larger pieces toward the inside and the lower half, and use smaller ones near the top. A slim tree shows every object clearly, so a few favorites look better than a packed collection. Ribbon or a gently placed pick can fill a gap without much weight.

A shaggy white or cream tree skirt covers the stand and hides the little bit of flock that will still fall during the first week.

A little care through the season

Once the tree is shaped and decorated, leave it be. The more you adjust branches, the more snow you lose. Dust it, if you need to, with a feather duster or a dry microfiber cloth, working from the top down along the direction of the branches.

At the end of the season, take the ornaments off first, then the lights, then dust the tree while it is still standing. Pack the sections loosely. If they will not go back into the original box without being crushed, use a breathable tree bag instead of forcing them. Skip a hot attic or a damp garage if you can. Heat and moisture are hard on the flocking.

Take your time on the first afternoon, handle the branches once, and a slim flocked tree will look like it snowed in the living room, without the mess of a real one.

Back to blog